Question: How do I reset my Ford Mondeo Immobiliser?

How do you fix an active Immobiliser?

You could try disconnecting the battery for a few minutes to reset the immobilizer in case its got into a knot due to the slow discharge its had. Then lock and unlock the car to set and unset the immobilizer.

Why is my ford Mondeo not starting?

The most common causes that hinders normal starting operation of your Mondeo are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.

Why is my immobiliser not working?

Many immobilizer problems can be fixed simply by simply replacing the battery in the key fob. If the actual immobilizer system in the vehicle is to blame, then it could be due to the wires being corroded or damaged. Perhaps the engine control unit or its sensors are malfunctioning or faulty.

How do I find my immobilizer PIN code?

0:171:21how to find pin code for immobilizer in 60 sec - YouTubeYouTube

How do you bypass a car immobilizer?

You can bypass the immobilizer by placing the key in keyhole hence deactivating the cars immobilizer to remote start. The added security with Mobokey allows the security to be activated as soon as the phone moves away from the car, so you dont have to worry about car security.

How do you start a Ford Mondeo keyless?

1:584:02Ford mondeo 2012-mk4 titanium. Unlock and start engine when ...YouTube

How do you change a starter motor on a Ford Mondeo Diesel?

1:414:56Ford Mondeo Mk4 diesel - replacing the starter motor - YouTubeYouTube

What does Immobiliser active mean?

The immobilizer system is responsible for keeping the car from turning on with an unregistered key. If the system is not allowing you to turn on the vehicle with a registered key, it is likely because of the presence of a second registered key, an automated payment device, or an automated toll road device.

How do I turn off immobilizer on Ford Galaxy?

With the ignition on and all accessories off leave the key in the lock in the run or on position for 61 minutes and until all the door locks cycle twice. 2. Then switch the key off and remove it for 30 seconds before testing to see if the car will start as normal.

How do you unlock a car immobilizer?

Turn the key to unlock your car door, but dont release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder.

How do I unlock my immobiliser?

0:174:57Immobiliser Not Working? Car Wont Start! Key Fob Faulty? Bypass ...YouTube

What is an immobilizer code?

The engine immobilizer is a state-of-the-art anti-theft system. When you insert your key into the ignition switch or bring a Smart Key fob into the vehicle, the key transmits an electronic code to the vehicle. Because the transponder chip is embedded in the key or Smart Key fob, it can be costly to replace.

Where do I find my emergency key access code?

The EKA code is found on the security information card supplied with your vehicle. The code is 4 digits long. The EKA code IS NOT the code in the key fob. The grey plastic tag on the keys IS NOT the EKA code, it is the ignition key code.

Tell us about you

Find us at the office

Chalcraft- Kurin street no. 49, 65214 Beijing, China

Give us a ring

Raylen Lenane
+27 813 510 167
Mon - Fri, 11:00-16:00

Tell us about you